Millipak MPVL20CA3 -200 Filter Unit 0.1 µm Gamma Compatible Millipore 9/16 in

Description

Millipak MPVL20CA3 -200 Filter Unit 0.1 µm Gamma Compatible Millipore 9/16 in
LAST ONE!!!!
IN STOCK, Ships immediately!!!
This is the CHEAPEST price ANYWHERE on a genuine part.
This is new, never used or installed.
THIS IS A GENUINE OEM MILLIPAK FILTER SET OF 3!! THIS IS NOT A CHEAP AFTERMARKET OR USED PART THAT WILL NOT LAST AND WILL NEED REPLACED!! DON'T WASTE TIME, MONEY, AND HASSLE REPLACING IT AGAIN!!!
SOLD AS A SET OF THREE FILTERS AS PICTURED. MULTIPLE QUANTITIES OF SETS OF THREE MAY BE AVAILABLE AS INDICATED IN AVAILABLE QUANTITY.
Get the best price ANYWHERE HERE!!!
Get your genuine high end part for much cheaper here.  Don't worry about old used parts breaking, this is brand new.  Don't settle for used parts this is brand new.  BETTER BUILT!!!
This part sells for over 5
Description
Catalogue Number
MPVL20CA3
Trade Name
Millipak
®
Description
Gamma Compatible Millipak
®
-200 Filter Unit 0.1 µm 9/16 in. HB/HB
Product Information
Device Configuration
Capsule
Connections, Inlet/Outlet
14 mm (9/16 in.) Hose Barb
Maximum Differential Pressure, bar (psid)
Forward: 4.1 bar (60 psid) @ 25 °C; 1.7 bar (25 psid) @ 80 °C; 0.35 bar (5 psid) @ 123 °C; Reverse: 0.7 bar (10 psid) @ 25 °C
Maximum Inlet Pressure, bar (psi)
5.2 bar (75 psi) @ 25 °C
Good Manufacturing Practices
These products are manufactured in a facility which adheres to FDA Good Manufacturing Practices.
Biological Information
Bacterial Endotoxins
Aqueous extraction contains ≤0.5 EU/mL as determined by the Limulus Amebocyte Lysate (LAL) Test
Media
Durapore
®
Sterilization
3 autoclave cycles of 90 min @ 123°C; not in-line steam sterilizable
Bacterial Retention
Samples were quantitatively retentive of a minimum
Brevundimonas diminuta
challenge concentration of 1 x 10⁷ CFU/cm² using ASTM
®
F838 methodology.
Wettability
Hydrophilic
Physicochemical Information
Pore Size
0.1 µm
Inlet Connection
Hose Barb
Outlet Connection
Hose Barb
Bubble Point at 23 °C
≥4830 mbar (70 psig) air with water
Flow Rate
8.5 L/min @ 2.45 bar ΔP
Gravimetric Extractables
The extractables level was equal to or less than 5 mg per device after 24 hours in water at controlled room temperature.
Non-Fiber Releasing
This product was manufactured with a Durapore
®
membrane which meets the criteria for a "non-fiber releasing" filter as defined in 21 CFR 210.3 (b) (6).
USP Bacterial Endotoxins
A sample aqueous extraction contains less than 0.5 EU/mL as determined by the Limulus Amebocyte Lysate (LAL) test.
Dimensions
Length
13.0 cm (5.1 in.)
Diameter
7.6 cm (3.0 in.)
Filtration Area
1000 cm²
Process Volume
100 L
Inlet Connection Diameter
9/16 in.
Outlet Connection Diameter
9/16 in.
Materials Information
Chemistry
Polyvinylidene Fluoride (PVDF)
Device Material
Polycarbonate
Support Material
Polycarbonate
Vent Cap Material
Polyvinylidene fluoride (PVDF)
Packaging Information
Material Size
3
Material Package
Double Easy-Open bag
Specifications
Oxidizable Substances
Will meet the USP Oxidizable Substances Test requirements after a water flush of ≥200 mL